Utilizzando il modulo RF-TIMBER CSA, è possibile verificare colonne in legno secondo la norma CSA O86-19. Il calcolo accurato della capacità di compressione delle aste di legno e dei fattori di regolazione è importante per le considerazioni di sicurezza e la progettazione. The following article will verify the factored compressive resistance in the RFEM add-on module RF-TIMBER CSA, using step-by-step analytical equations as per the CSA O86-19 standard including the column modification factors, factored compressive resistance, and final design ratio.
Using the RF-TIMBER CSA module, timber beam design is possible according to the CSA O86-14 standard. Accurately calculating timber member bending resistance and adjustment factors is important for safety considerations and design. The following article will verify the factored bending moment resistance in the RFEM add-on module RF-TIMBER CSA using step-by-step analytical equations as per the CSA O86-14 standard including the bending modification factors, factored bending moment resistance, and final design ratio.
Anhand eines Verifikationsbeispiels soll die Bemessung eines torsionsbeanspruchten Trägers nach AISC Design Guide 9 gezeigt werden. Die Bemessung erfolgt mit dem Zusatzmodul RF-STAHL AISC und der Modulerweiterung RF-STAHL Wölbkrafttorsion mit sieben Freiheitsgraden.
Questo articolo spiega come determinare i carichi sulla base delle situazioni di forza interne definite nell'estensione RF-/STEEL Warping Torsion del modulo aggiuntivo RF-/STEEL EC3. Poiché questo nuovo programma consente anche di analizzare strutture di travi a catena estratte oltre a intere strutture di travi a catena, è necessario determinare separatamente i carichi della struttura parziale. Per fare ciò, è stata sviluppata una speciale funzione di trasformazione che determina nuovi carichi di tutte le strutture parziali (a seconda delle forze interne calcolate in RFEM/RSTAB) in base a ciascuna situazione di carico per l'analisi della torsione di ingobbamento geometricamente non lineare con sette gradi di libertà.
Requirements for the design of structural stability are given in the AISC 360 – 14th Ed. Chapter C. In particular, the direct analysis method provisions, previously located in Appendix 7 of the AISC 360 – 13th Ed., are described in detail. This method is considered an alternative to the effective length method, which in turn eliminates the need for effective length (K) factors other than 1.0.
L'estensione del modulo RF-/STEEL Warping Torsion del modulo aggiuntivo RF-/STEEL EC3 consente di progettare aste con sezioni trasversali asimmetriche. La nuova caratteristica è totalmente integrata nel modulo e può essere attivata per i set di aste.